RELEASE #1

I found the solution in a large store.

I found that, ie blue leds for cars of youngs.

The site to put them it is the plastic mask which surrounds the ignition key. No problem to remove it, it is enough to draw a little strong top, there are nipples which return in rubber discs as for theside ones.

After having striped the plastic a little (So that the adhesive adheres well), I stuck the leds to the adhesive hot on both sides of the hole for the ignition key.

(Put mouse on pic)

THE RESULT

Everything is ok! I know where are my buttons, even during black night!

THE POSTMAN ALWAYS RING TWICE

That's my problem in fact. As I did for my GPS mounting or for my leds lights, I always have to do it twice as so as to obtain what I wanted to do.

But finally, during winter, it's goog to have someting to do, and if the result is better than it was... it's a good thing.

So let's go! I bought 4 green leds, 2 red leds, 2 blue leds and 8 resistances (470 Ohms).

That's always the same thing. You have to weld the resistance to the + of the led (The longest part) and you also have to isolate it.

When the leds are assembled, you have to take the Dremel as so as to make 3mm holes in the dashboard. I choose to put green led under the four buttons and a red led and a blue led (Hot and cold) along the potentiometers.

Then you put the leds and you cement them with hot glue. Be careful not to glue the buttons or the potentiometers. If you do, they won't work any more!

Then you only have to weld wires

and isolate them